Product Overview
- Model Number: 25SV24924
- Height: 8.2 ft. with festive Santa hat, 7.7 ft. without the hat
- Motion: Head, mouth, and arm with candy cane
- Sound: 5 classic Chewbacca™ sounds
- Activation: Infrared motion sensor
- Indoor item
-
Power Requirements: 2A Indoor Adapter
Replacement Parts
Purchase Replacement Parts here
Limited stock: Parts available while supplies last!
Parts List:
Assembly Instructions
- Recommended: 1 adult assembly (30 minutes approximately)
- Ensure: All parts are properly connected as shown in the instruction manual
-
Download: Parts List and Assembly Instructions PDF
Control Box Settings
Setting |
Description |
OFF |
In this mode, the item is only activated for a 15 second activity cycle if the Step Pad is pressed. Otherwise, it remains off. |
TIMER/SENSOR |
Set the switch to TIMER/SENSOR to enable a 6-hour sensor mode followed by 18 hours off, repeating daily. During the active period, the IR sensor triggers one animation and sound cycle when motion is detected within 4 m (13 ft) and an 80° range. |
| Adjustable dial; turn all the way down to mute. |
Important Setup Tips
- Adapter must be tightly screwed in at the Function Control Box and plugged into a wall outlet.
- Switch on the control box should be set to your preferred mode.
- If not functioning properly, ensure that cables are connected to their corresponding cable as shown in the instruction sheet.
- Be sure nothing is blocking movement or caught in moving parts.
- Ensure the base surface is flat and nothing blocks the movement.
- Check that the speaker volume is turned up.
- Indoor item.
Troubleshooting & FAQs
Where is the sensor located?
A: The sensor is on the belt that goes across the chest.
What power adapter should I use with 7.5FT Animated Chewbacca?
A: This item requires 2A Indoor Adapter.
Can the fur bodysuit be washed in the washing machine?
A: No, the bodysuit cannot be washed in the washing machine. We recommend to use a dust cloth or soft damp cloth to gently wipe the fur in a downward direction, then allow it to air dry.
What's the size of the screws that are used to attach Parts E and D?
A: Wingnut screw M4 10 mm.