Product Overview
- Model Number: 25SV24807
- Height: 7.5 ft.
- Motion: Head, mouth, left arm
- Sound: Speak 6 different phrases
- Lighting: Selectable LCD eyes: 8 different eye options, color-changing broom
- Activation: Infrared motion sensor
- Indoor item
- Power Requirements: 3A Indoor Adapter
Replacement Parts
Purchase Replacement Parts here
Limited stock: Parts available while supplies last!
Parts List:
Assembly Instructions
- Recommended: 1 adult
- Ensure: All parts are properly connected as shown in the instruction manual
- Download: Parts List and Assembly Instructions PDF
Control Box Settings
Setting |
Description |
LIGHTS ONLY |
Lights activate indefinitely until the setting is changed. |
TIMER/SENSOR |
Lights stay on for 6 hours while the IR sensor is active. Motion within 13 ft (80° range) triggers animation and sound. Followed by 18 hours off. Repeats daily until the setting is changed. |
OFF/STEP PAD |
Activates one cycle when triggered by a Step Pad or Try Me Button (not included). Stays off otherwise. |
LED MODE |
The LED Mode button allows you to toggle between 8 different light functions: red, yellow, green, aqua, blue, purple, white and color changing. |
| Mode button toggles through 8 LCD eye options. | |
| Adjustable dial; turn all the way down to mute. |
Important Setup Tips
- Adapter must be tightly screwed in at the Function Control Box and plugged into a wall outlet.
- Switch on the control box should be set to your preferred mode.
- If not functioning properly, ensure that cables are connected to their corresponding cable as shown in the instruction sheet.
- Be sure nothing is blocking movement or caught in moving parts.
- Ensure the base surface is flat and nothing blocks the movement.
- Check that the speaker volume is turned up.
- Indoor item.
Troubleshooting & FAQs
What power adapter should I use with 7.5 ft. Animated Nightshade Witch?
A: This item requires 3A Indoor Adapter.
How tall is this item?
A: The Animated Nightshade Witch is 7.5 ft tall with a hat and 6.5 ft tall without a hat.
The head is droopy/the motion is too loose. What should I do?
A: If you find your Nightshade Witch head motion is a little too loose, please follow these steps:
1. Remove the head from the body if assembled.
2. Use a M2.0 Hex Key and tighten the hex screw at the top of the silver rod. It will be right above the metal ring.
3. Attach the head to the body. Make sure that the metal rod is fully seated with flat part not showing before tightening the wingnut screw.
Flat part of the rod not showing:
What's the size of the head screw?
A: Head screw: M5 20mm